Looking for:
Acu rite manual |
Acu rite manual
Contact Customer Support at or visit www. To ensure the best possible product performance, please read this manual in its entirety and retain it for future reference.
Unpacking Instructions Remove the protective film that is applied to the LCD screen prior to using this product. Install or Replace Batteries AcuRite recommends high quality 3.
Replace the battery cover. Repeat steps to setup the best product performance. Remove the battery compartment cover. Insert 3 x AAA alkaline batteries into the battery compartment, as shown. Page 6: Model The display can be expanded to track additional areas by using compatible Temperature Sensors optional; sold separately. Compatible Sensors are available at: www. Proper placement of both the display and wireless sensor are critical to the accuracy and performance of this product.
Display Placement Place the display in a dry area free of dirt and dust. Display stands upright for tabletop use or is wall-mountable. Page 9: Troubleshooting see page 7. If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www. Do not use caustic cleaners or abrasives. Keep away from dust, dirt and moisture. Clean ventilation ports regularly with a gentle puff of air. Wireless Sensor Care Clean with a soft damp cloth.
Page Customer Support Customer Support AcuRite customer support is committed to providing you with best-in- class service. For assistance, please have the model number of this product available and contact us in any of the following ways: AcuRite Visit us at www. Outdoor temp registers after brief power outage.
How to I fix it? Model w, temp reading of to F. Have replaced batteries on indoor and outdoor unit no change. Is it okay to oil that shaft? Hello,I purchased and set up the weather station model SBL today. How does the weather station display the outdoor high and low temperatures? It's only showing these for the indoor temps and the manual does not indicate how to change this to show the outdoor high and low, which is my preference.
Thank you,George. I just replaced the batteries in the sensor. I looked at the troubleshooting guide, but it does not address this. How do I get them to find each other? My w unit is plugged into the wall. It will not drop below the max temp for the day until am then goes to the current temp. Can't find the answer to your question in the manual? Is your question not listed? Contact Customer Support at or visit www. P ackage Contents Product R egistration Sensor Setup Display Setup Bac klight Settings Placement Guidelines Using the W eather St ation T roubleshooting Batter y..
FCC Infor mation Customer Suppor t W arranty Need help?
❿ ❿
No comments:
Post a Comment